Filter
Top Products
31Sending Faxes
ENGLISH
Sequential Broadcasting
Sending a Document to More Than One Location
Sequential broadcasting sends one document to more than one location.
You can send to a total of 110 locations (70 locations for the JX210P model) as follows:
You can enter the one-touch speed dialing and coded speed dialing locations in any order. You
simply press the one-touch speed dialing button, or press [Coded] or [Directory] followed by the
two-digit code.
You can also include one location using regular dialing. Remember that when using regular
dialing, you must press [Start/Copy] after entering the number.
1 Load the document face up into the ADF.
See “Loading Documents and Paper” on page 21.
You can set the scanning resolution and contrast (see page 24).
2 Dial the receiving party’s fax numbers as you need.
You can also press [Redial] to redial the last number dialed with the numeric buttons.
3 Press [Start/Copy].
z The fax reads the document into memory and begins sending.
z To cancel a transmission, press [Stop/Reset] during dialing or transmission. All
transmissions in the sequence are canceled.
z One-touch speed dialing
z Coded speed dialing
z Regular dialing (Numeric buttons dialing)
= 9 locations
= 100 locations (60 locatitons for the
JX210P model)
= 1 location
Note
z You must press each button within 10 seconds of the preceding one. The fax begins the
operation approximately 10 seconds after you press the last button.
z The regular dialing number must be entered last.
TEL= 3456xxxx