Filter
Top Products
61Settings and Activity Reports
ENGLISH
ACTIVITY REPORT
Summarizes the information for the sending and receiving activities of your fax after 20
transactions. For automatic printing, see <ACTIVITY REPORT> on page 57.
Transactions in the ACTIVITY REPORT are listed chronologically.
ONE-TOUCH SPEED DIAL TELEPHONE NO. LIST
Lists the numbers and names registered under one-touch speed dialing buttons.
CODED SPEED DIAL TELEPHONE NO. LIST
Lists the numbers and names registered under coded speed dialing codes.
USER’S DATA LIST
Lists the current settings of the fax and the registered sender information.
MEMORY LIST
Lists the documents currently stored in the fax’s memory (see page 40).
TX REPORT (Transmission Report)
Normally the fax does not print an activity report for transmitting, but you can set the fax to print
an activity report every time you send a document. See <TX REPORT> on page 56.
You can set the fax to print an activity report only when an error occurs during transmitting. See
<TX REPORT> on page 56.
RX REPORT (Reception Report)
Normally the fax does not print an activity report for receiving, but you can set the fax to print an
activity report every time you receive a document. See <RX REPORT> on page 56.
You can set the fax to print an activity report only when an error occurs during receiving. See
<RX REPORT> on page 56.
MULTI TX REPORT (Multi Transmission Report)
Lists the result of a sequential broadcasting.
If you set the fax to print the TX REPORT and then use sequential broadcasting, the MULTI TX
REPORT will be printed instead of the TX REPORT. See <TX REPORT> on page 56.
Note
JX510P model:
Faxes or messages stored in the memory are backed up automatically if the power is turned off or
fails. If however, the data cannot be retrieved when the power is turned on again, the MEMORY
CLEAR REPORT is printed automatically.
JX210P model:
The MEMORY CLEAR REPORT is printed automatically when power is restored after a power
failure. See “MEMORY CLEAR REPORT (JX210P only)” on page 85.