Filter
Top Products
43Using TAM Mode (JX510P only)
ENGLISH
7 Hang up the Handset and press [Stop/Reset].
The fax returns to standby mode.
Setting TAM Mode
Setting TAM mode allows you to receive telephone messages (ICM) and fax transmissions while the
fax is unattended.
1 Press [TAM] to set TAM mode.
z When you set TAM mode, the TAM Lamp lights up and the outgoing message is played.
z To cancel TAM mode, press [TAM] again. This turns off the TAM Lamp. If you have any new
telephone messages, the messages are played automatically.
Note
You cannot delete <OUTGOING MESSAGE> or <ALT OUTGOING MSG>. To record a new
outgoing message or alternative outgoing message, repeat steps 1 to 7. An old outgoing message
or alternative outgoing message will be deleted automatically when you record a new message.
Note
z <NO OGM> is displayed on the LCD when no outgoing message has been recorded. You must
record an outgoing message before you can set TAM mode (see page 42).
z A maximum of 55 messages, including telephone messages, outgoing message, alternative
message, voice memos, Fax/Tel message and forwarding message, with a total maximum
recording time of 30 minutes can be recorded.
z You can set a maximum recording time of 240 seconds for telephone messages (see page 44).
z The number of messages or total recording time may be reduced if there are many faxes stored
in memory.
z If you have any new telephone messages, the TAM Lamp blinks and the number of messages
appears on the LCD.
z The day and time when the telephone message was recorded, the number of telephone
messages and the number of the message being played (ICM No.) are displayed whenever a
message is played (see page 46).
z When the fax is set to <MANUAL MODE> and <MAN/AUTO SWITCH> has been set to <OFF>
(see page 57), TAM mode will be activated if the fax rings 15 times and the call is not answered
(only when an outgoing message has been recorded). When the call is disconnected, the fax
returns to <MANUAL MODE>.
15:00 :00