Filter
Top Products
48 Using TAM Mode (JX510P only)
ENGLISH
Using Remote Control
1 Call home.
2 The outgoing message will be played.
3 Press [#] while the outgoing message is playing. Enter your password when you
hear the beeps indicating that you should enter your password.
When your password is accepted, you will hear a confirmation tone (a short series
of beeps).
4 The fax will now accept remote control commands (see “List of Remote Control
Commands” on page 49).
For example, press [1][1][#] to play back any telephone messages you may have received.
When playback has finished, press [9][9][#] to end the remote control.
5 End the remote control and hang up the Handset.
Note
z A password is required to use the remote control features. However, if <PIN ENTRY> is set to
<OFF> (see page 59), it is not necessary to enter your password when you use the
<FORWARDING MSG> feature (see page 50).
z If you enter an invalid password, you will hear an error tone. If you enter two invalid passwords
consecutively, the call will be disconnected.
z You should enter a remote command within 20 seconds of entering your password. If more than
20 seconds elapse after you enter your password and you do not enter a remote command, the
call will be disconnected.
z The remote control features can be used even when the fax is set to a mode other than TAM
mode.
z In <FAX ONLY MODE>, the outgoing message will not be played. Press [#] when the call is
connected.
z In <Fax/Tel Mode>, press [#] while the Fax/Tel message is playing. If you have not recorded a
Fax/Tel message, press [#] when the call is connected.
z When the fax is set to <MANUAL MODE> and <MAN/AUTO SWITCH> has been set to <OFF>
(see page 57), TAM mode will be activated if the fax rings 15 times and the call is not answered
(only when an outgoing message has been recorded). When the call is disconnected, the fax
returns to <MANUAL MODE>. Press [#] while the outgoing message is playing. Then, enter
your password when you hear the beeps.