Filter
Top Products
39Receiving Faxes
ENGLISH
6 Use [{] or [}] to select the type of <CALL REJECTION> setting (JX510P only)
you want, then press [Start/Copy].
You can select from the followings:
z <ANONYMOUS>: The fax rejects calls from any callers who have blocked their phone/fax
number from the caller ID service.
z <SELECTIVE>: The fax rejects calls from specific phone/fax numbers you place in
<REJECTED NUMBER> list.
z <OUT OF AREA>: The fax rejects calls from any callers in an area that does not have the
caller ID service.
z <SHOW IN HISTORY?>: Determine if the fax stores phone/fax number for rejected calls in
memory.
7 Use [{] or [}] to select <ON> (YES), then press [Start/Copy].
z If you set to <OFF>, the setting goes on to the next <CALL REJECTION> setting.
z If you set <ANONYMOUS> or <OUT OF AREA> to <ON>, select a method to reject calls in
<REJECTION METHOD>. Press [Start/Copy], then proceed to step 12.
z If you set <SELECTIVE> to <ON>, register the specific phone/fax numbers you want to
reject in <REJECTED NUMBER> list. Follow the steps below.
z If you set <SHOW IN HISTORY?> to <YES> or <NO>, <TEL REGISTRATION> is
displayed on the LCD.
If you want to finish the <CALLER ID> setting, press [Stop/Reset] to return to standby
mode.
If you want to continue to set other <CALL REJECTION> settings, press [{], and then
repeat from step 2 again.
8 Press [Start/Copy].
9 Use [{] or [}] to select the number of <REJECTED NUMBER> list (00-09) under
which you want to register the phone/fax number, then press [Start/Copy].
10 Enter the phone/fax number using the numeric buttons, then press [Start/Copy].
11 To assign additional numbers, repeat the procedure from step 9.
To finish, press [Menu], then select a method to reject calls in <REJECTION
METHOD>. Press [Start/Copy].
12 Use [{] or [}] to select <PLAY MESSAGE> or <DISCONNECT>, then press
[Start/Copy].
z <PLAY MESSAGE>: The call will be disconnected after <OUTGOING MESSAGE> (see
page 42) is played. If you set <SELECTIVE> to <ON> in step 6, and want to select this
setting, <OUTGOING MESSAGE> must have been recorded.
z <DISCONNECT>: The call will be disconnected without notice.
13 Press [Stop/Reset] to return to standby mode.