Filter
Top Products
E
62
Change to AC adaptor power
or load a fresh set of batteries
(supplied by you). (page 57)
Remove the tape cartridge.
After making sure that the ink
ribbon is not broken, take up
all the slack. Reload the tape
cartridge into the printer.
(Startup Guide, page 13)
Important!
• Always make sure you
remove all slack from the ink
ribbon before loading a tape
cartridge into the printer.
• If the ink ribbon is broken,
replace the tape cartridge
with a new one.
Have the tape cutter replaced by
your retailer or your local CASIO
service center.
Turn off the printer, remove the
tape cartridge, and remove
the jammed label.
Change the MARGINS
setting to NARROW, MEDIUM
or WIDE. (page 26)
Change the tape cut mode
setting to something other
than UNCUT. (page 38)
Symptom Recommended ActionPossible Cause
Battery power is low.
Slack in the ink ribbon
when the tape
cartridge was loaded
in the printer.
The tape cutter is dull.
Tape is jammed in the
tape outlet.
NONE is selected for
the MARGINS setting
of the format being
used.
UNCUT is selected for
the tape cut mode.
No tape
comes out
when I
press
PRINT.
The ink
ribbon is
coming out
of the tape
outlet
together
with the
tape.
The tape
will not cut.
Symptom Recommended ActionPossible Cause
The tape
will not cut.
The label is too short.
The tape cutter is dull.
FULL CUT or UNCUT
is selected for the tape
cut mode.
You are printing on
magnetic tape.
The label is too short.
The backing paper has
not been removed.
The location or the
surface is not
compatible.
Use scissors to cut the labels
after printing is complete.
Have the tape cutter replaced
by your retailer or your local
CASIO service center.
Change the tape cut mode
setting to CONT HALF CUT or
FULL+HALF CUT.
Half cutting is not supported
for magnetic tape. Use
scissors to cut the labels after
printing is complete.
• Select UNCUT for the tape
cut mode whenever printing
on magnetic tape or
reflective tape (page 39).
Use scissors to cut the labels
after printing is complete.
Remove the backing paper.
(Startup Guide, page 25)
Do not try to affix a label to a
surface that is rough, wet, oily,
or dirty. (Startup Guide, page
25)
Less than approximately 31mm
(1 1/4") with narrow margins
Less than approximately 38mm
(1 1/2") with medium margins
Less than approximately 50mm
(1 15/16") with wide margins
The printer
will not half
cut.
Less than approximately 31mm
(1 1/4") with narrow margins
Less than approximately 38mm
(1 1/2") with medium margins
Less than approximately 50mm
(1 15/16") with wide margins
The label
does not
stick.