Implementing BGP on Cisco IOS XR Software
How to Implement BGP on Cisco IOS XR Software
RC-118
Cisco IOS XR Routing Configuration Guide
OL-14356-01
Disabling a BGP Neighbor
Perform this task to administratively shut down a neighbor session without removing the configuration.
SUMMARY STEPS
1. configure
2. router bgp as-number
3. neighbor ip-address
4. shutdown
5. end
or
commit
Step 13
route-policy route-policy-name {in | out}
Example:
RP/0/RP0/CPU0:router(config-bgp-af)#
route-policy pe_ce_out_policy out
Specifies a routing policy for an outbound route. The policy
can be used to filter routes or modify route attributes.
Step 14
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-bgp-af)# end
or
RP/0/RP0/CPU0:router(config-bgp-af)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
–
Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Command or Action Purpose