Filter
Top Products
Implementing EIGRP on Cisco IOS XR Software
How to Implement EIGRP on Cisco IOS XR Software
RC-157
Cisco IOS XR Routing Configuration Guide
OL-14356-01
Step 6
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 7
router eigrp as-number
Example:
RP/0/RP0/CPU0:router(config)# router eigrp 100
Configures an EIGRP routing process.
Step 8
address-family {ipv4 | ipv6}
Example:
RP/0/RP0/CPU0:router(config-eigrp)#
address-family ipv4
Enters an address family configuration mode.
Step 9
route-policy route-policy-name {in | out}
Example:
RP/0/RP0/CPU0:router(config-eigrp-af)#
route-policy IN-IPv4 in
Applies a routing policy to updates advertised to or received
from an EIGRP neighbor.
Step 10
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-eigrp-af)# end
or
RP/0/RP0/CPU0:router(config-eigrp-af)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
–
Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
–
Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Command or Action Purpose