Filter
Top Products
Implementing BGP on Cisco IOS XR Software
How to Implement BGP on Cisco IOS XR Software
RC-60
Cisco IOS XR Routing Configuration Guide
OL-14356-01
Configuring Aggregate Addresses
Perform this task to create aggregate entries in a BGP routing table.
SUMMARY STEPS
1. configure
2. router bgp as-number
3. address-family {ipv4 unicast | ipv4 multicast | ipv6 unicast | ipv6 multicast}
4. aggregate-address address/mask-length [as-set] [as-confed-set] [summary-only] [route-policy
route-policy-name]
5. end
or
commit
DETAILED STEPS
Command or Action Purpose
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2
router bgp as-number
Example:
RP/0/RP0/CPU0:router(config)# router bgp 120
Enters BGP configuration mode, allowing you to configure
the BGP routing process.
Step 3
address-family {ipv4 unicast | ipv4 multicast |
| ipv6 unicast | ipv6 multicast}
Example:
RP/0/RP0/CPU0:router(config-bgp)#
address-family ipv4 unicast
Enters address family configuration mode for the specified
address family.