Filter
Top Products
Implementing RIP on Cisco IOS XR Software
Configuration Examples for Implementing RIP on Cisco IOS XR Software
RC-349
Cisco IOS XR Routing Configuration Guide
OL-14356-01
Configuring Redistribution for RIP: Example
The following example shows how to redistribute Border Gateway Protocol (BGP) and static routes into
RIP.
The RIP metric used for redistributed routes is determined by the route policy. If a route policy is not
configured or the route policy does not set RIP metric, the metric is determined based on the redistributed
protocol. For VPNv4 routes redistributed by BGP, the RIP metric set at the remote PE router is used, if
valid.
In all other cases (BGP, IS-IS, OSPF, EIGRP, connected, static), the metric set by the default-metric
command is used. If a valid metric cannot be determined, then redistribution does not happen.
route-policy ripred
set rip-metric 5
end-policy
!
router rip
vrf vpn0
interface GigabitEthernet0/6/0/2
!
redistribute connected
default-metric 3
!
vrf vpn1
interface GigabitEthernet0/6/0/3
!
redistribute bgp 100 route-policy ripred
redistribute static
default-metric 3
!
!
Configuring Route Policies for RIP: Example
The following example shows how to configure inbound and outbound route policies that are used to
control which route updates are received by a RIP interface or sent out from a RIP interface.
prefix-set pf1
10.1.0.0/24
end-set
!
prefix-set pf2
150.10.1.0/24
end-set
!
route-policy policy_in
if destination in pf1 then
pass
endif
end-policy
!
route-policy pass-all
pass
end-policy
!