Filter
Top Products
Implementing Static Routes on Cisco IOS XR Software
How to Implement Static Routes on Cisco IOS XR Software
RC-424
Cisco IOS XR Routing Configuration Guide
OL-14356-01
How to Implement Static Routes on Cisco IOS XR Software
This section contains the following procedures:
• Configuring a Static Route, page RC-424 (required)
• Configuring a Floating Static Route, page RC-425 (optional)
• Configuring Static Routes Between PE-CE Routers, page RC-427 (optional)
• Changing the Maximum Number of Allowable Static Routes, page RC-429 (optional)
• Associating a VRF with a Static Route, page RC-430 (optional)
Configuring a Static Route
This task explains how to configure a static route.
SUMMARY STEPS
1. configure
2. router static
3. vrf vrf-name
4. address-family {ipv4 | ipv6} {unicast | multicast}
5. prefix mask [vrf vrf-name] {ip-address | interface-type interface-instance} [distance] [description
text] [tag tag] [permanent]
6. end
or
commit
DETAILED STEPS
Command or Action Purpose
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2
router static
Example:
RP/0/RP0/CPU0:router(config)# router static
Enters static route configuration mode.
Step 3
vrf vrf-name
Example:
RP/0/RP0/CPU0:router(config-static)# vrf vrf_A
(Optional) Enters VRF configuration mode.
If a VRF is not specified, the static route is configured under
the default VRF.