Filter
Top Products
Disassembly, Reassembly and Lubrication
CL-S6621 3-46
2. Remove the “Spring Head Holder” () from the “SA Head Adjust Lever” Block.
3. In the “SA Head Adjust Lever” Block, disengage the 3 E-rings (E-Ring 3) () to detach the
“SA Head Adjust Lever” from the “Base Head Adjust” Block.
4. Remove the 1 screw (PHT (#2), M2x6) (), and detach the 1 washer (Plain, 2.6x6.5x0.5)
and “Spring, Adjust Cam”. Next, pull out the “Bush Head Adjust” from the “Guide, Head
Adjust (Spring)” and detach the “Guide, Head Adjust (Spring)” and “Cam Head Adjust” from
the “Base Head Adjust”.
5. Pull out the “Bushing Head” (2 pcs.), and then remove the 1 screw (BH, M3x4 (NI)) and
detach the “Plate Head Earth” from the “Plate Holder Head”.
Notes on reassembling:
• Apply FLOIL G-311S to the following places. (See the mark
Ì shown in the figure.)
Plate Holder Head: Surface where the “Spring Head Holder” () contacts and its opposite
side.
Base Head Adjust: Holes (5 pcs.) and 1 groove.
• When assembling the “Spring Head Holder”:
Assemble the “Spring Head Holder” (“D”) on the “SA Head Adjust Lever” Block as shown in
the magnified view. Then, insert them into the “Plate Holder Head” Block as shown.
D
"Plate Holder Head" Block
Spring Head Holder
"SA Head Adjust Lever" Block
"Plate Holder Head" Block
FLOIL G-311S
Spring Head Holder
Base Head Adjust
SA Head Adjust Lever
E-Ring 3
PHT (#2), M2x6
Plain, 2.6x6.5x0.5
Spring, Adjust Cam
Bush Head Adjust
Cam Head Adjust
Guide, Head Adjust (Spring)
Bushing Head
Plate Head Earth
BH, M3x4 (NI)
Bushing Head
Plate Holder Head
(On the pposite side)
a
b