Filter
Top Products
Disassembly, Reassembly and Lubrication
3-49 CL-S6621
FLOIL G-311S
Pinion Sensor L
Leaf Pinion Sensor L
Carriage Adjust Sensor L
A
Shaft Lead Screw
A’
Notes on reassembling:
• When assembling the “Leaf Pinion Sensor L” and “Pinion Sensor L” on the “Carriage Adjust
Sensor L”:
1) First, place the “Leaf Pinion Sensor L” inside the “Carriage Adjust Sensor L” with the
convex side facing up.
2) Next, place the “Pinion Sensor L” inside the “Carriage Adjust Sensor L”. Pat attention to
its installing direction.
3) Insert the projection “A” into the groove “A’ “of the “Shaft Lead Screw”.
4) Apply FLOIL G-311S to the “Leaf Pinion Sensor L”. (See the mark
Ì shown below.)
• Apply FLOIL G-311S to the groove of “Shaft Lead Screw”.
• After assembling each part, arrange the wires as follows.
1) Turn the “Gear Lead Screw L” in the direction shown by the arrow to move the “Carriage
Adjust Sensor L” to the right until it stops.
2) In this condition, run the 5 wires from the “SA Ref Sen PCB” on the top side as shown
below. Hook them on the hooks.
3) Run the 2 wires from the “SA, Head Up Switch” as shown below. Hook them on the right
side hook.
4) Bind the wires with “Wire Tie” at two places.
SA, Head Up Switch
Wire Tie
Gear Lead Screw L
Carriage Adjust Sensor L
[Bottom View]
5 wires from the "SA Ref Sen PCB" on the top side.
Hook
Hook
Wire Tie