Filter
Top Products
- 102 -
GS V m ・・・ (1)
GS V m n ・・・ (2)
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Cutting the paper
[Code] (1)<1D>H<56>H<m>
(2)<1D>H<56>H<m><n>
[Range] (1)0≦m≦1、48≦m≦49
(2)m=65、66
0≦n≦255
[Outline] [The specification which is common to the model]
Performs the specified paper cutting.
m Function
0,48 Full cut
1,49 Partial cut (Leaving a bridge area uncut)
Paper feed by “cut position + {n×basic calculation pitch}” and full cut
65
Paper feed by “cut position + {n×basic calculation pitch}” and partial cut
66
[Caution] [The specification which is common to the model]
• In STANDARD MODE, this command only works when it is entered at the beginning of a line.
• Control to make the length of cut paper less than 10 mm is not executed.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n ≠0, the paper is fed by “n x
basic calculation pitch” inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P. The paper feed amount is calculated with the vertical
basic calculation pitch (y). A fraction resulting from the calculation is corrected with the
minimum pitch of the mechanism, and the remainder is omitted.
[The specification which depend on the model]
CT-S300/CT-S2000/CT-S4000/CT-S310/PMU2XXX
• With label- or BM-supported model, this command does not function at the setting of BM
paper/label paper setting.