Filter
Top Products
- 282 -
4.2.3 MSW3
●MSW3-1： Auto-cutter return
[Outline] Select return method from cutter lock error.
OFF(0) ON(1)
Resum Cttr Err Valid Invalid
ON (1) OPERATION: Return by command.
After removing error cause, return with command <DLE ENQ n>.
OFF (0) OPERATION: Return with FEED switch.
After removing error cause, return by long pressing FEED SW (1 sec or longer).
●MSW3-2： Clearing Cover Open Error
[Outline] Selects the method of clearing Cover Open error.
OFF(0) ON(1)
Resum Open Err Close Command
Operation at ON (1):
When the printer detects that cover is closed and the printer receives a command
<DLE+ENQ+n>, the error is cleared.
Operation at OFF (0):
When the printer detects that the cover is closed, it automatically clears the error.
*With BD2-2220, Cover Open corresponds to Head Up (Platen Open).
●MSW3-3： Parallel 31 pin
[Outline] Printer can be reset by parallel I/F –31 Pin signal. Select the handling of this signal.
OFF(0) ON(1)
Parallel 31 pin Valid Invalid
ON (1) OPERATION: Used as reset signal
OFF (0) OPERATION: Not used as reset signal