Filter
Top Products
BD2-2220
• Setting memory with 1 (a = 1) • Setting memory switch 3 (a = 3)
n b (Set Value) Function n b (Set Value) Function
48 (Default) Reports the power on. 48 (Default) After clearing cutter error, can be restored by Feed SW.
1 1
49 Does not report power on.
49 After clearing cutter error, cannot be restored by Feed SW.
48 (Default) Sets input buffer capacity to 4K bytes. 2 48 (Default) Reserved
2
49 Sets input buffer capacity to 45 bytes. (Note)
48 (Default) Resets with parallel pin 31.
3
48 (Default) Sets input buffer full and offline to be Busy.
49 Does not reset with parallel pin 31.
3
49 Sets to be busy with input buffer full.
4 48 (Default) Reserve
At the occurrence of receiving error, replaces the data with
“?”.
48 (Default)
5 48 (Default) Reserve
4
6 48 (Default) Reserve
49 At the occurrence of receiving error, ignores the data.
7 48 (Default) Reserve
48 (Default) Disables CR (0DH).
Sets head-up* error during printing to be auto recovery
error.
5
48 (Default)
49 Enables CR (0DH).
8
6 48 (Default) Reserved
Sets head-up* error during printing to be recoverable
error.
49
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
8 48 (Default) Reserve
*
Name depends on a mechanism to use.
LT2X20
series： Head-down/Head-up
• Setting memory switch 2 (a = 2)
LT2X21
series： platen-close/platen-open
n b (Set Value) Function
1 49 (Default) Reserve
2 48 (Default) Reserve
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After head-down* and PE recovery, prints as it is.
After head-down* and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
5
49
6 49 (Default) Reserve
7 48 (Default) Reserve
8 48 (Default) Reserve
- 163 -