Filter
Top Products
- 97 -
2.2.9 Panel Switch Commands
ESC c 5 n
CT-S280 CT-S300 CT-S2000 CT-S4000 BD2-2220 CT-S310
support model
PMU2XXX
[Function] Enabling/disabling the panel switches
[Code] <1B>H<63>H<35>H<n>
[Range] 0≦n≦255
[Outline] [The specification which is common to the model]
Enabling/disabling the FEED switch.
• “n” is valid only for the lowest bit (n0).
• Control by the lowest bit (n0) is shown as follows:
n0 Condition
0 FEED switch (LF-SW signal) valid
1 FEED switch (LF-SW signal) invalid
[Caution] • When the FEED switch is disabled with this command, the paper cannot be fed by operating the
FEED switch.
• While switch operation is waited at the execution of macro, the FEED switch is always enabled
regardless of the setting of this command but no paper feed operation is carried out.
[Default] n=0
[Sample Program]
LPRINT CHR$(&H1B);"c5";CHR$(0); ･････ When enabling the FEED switch
LPRINT CHR$(&H1B);"c5";CHR$(1); ･････ When disabling the FEED switch