Filter
Top Products
- 58 -
[Caution] [The specification which is common to the model]
• This command is valid for all characters (alphanumeric, kana, and kanji) except for HRI
characters.
• This command is ignored if either the vertical magnification or horizontal magnification is out of
the defined range.
• In PAGE MODE, the vertical direction means the top-bottom direction of each character. The
horizontal direction means the side-to-side direction of each character. If characters of different
vertical magnification are contained in a line, the baseline of each character is lined up.
• Horizontal and vertical magnification can also be specified/canceled by ESC ! but the setting of
command last processed is valid.
• In STANDARD MODE, the vertical direction is defined as the paper feed direction, and the
horizontal direction is defined as the direction perpendicular to the paper feed.
[The specification which depend on the model]
CT-S280/CT-S300/CT-S2000/CT-S4000/CT-S310
• Setting memory SW 3-7 to ON allows the horizontal and vertical relations to be interchanged
when 90°-right-turnning of character is specified.
[Default] n=0
[See Also] ESC !