Filter
Top Products
CT-S4000
• Setting memory switch 4 (a = 4) • Setting memory switch 5 (a = 5)
n b (Set Value) Function n B (Set Value) Function
48 (Default)
At the selection of Black mark paper/ label paper, disables
auto end-measurement.
48 (Default) Buzzer sound enabled
1
Buzzer sound disabled 49
1
49
At the selection of Black mark paper/ label paper, enables
auto end-measurement.
48 (Default) Basic calculation pitch (180 dpi / 360 dpi)
2
49 Basic calculation pitch (203 dpi / 406 dpi)
48 (Default) Setting the first position at power ON disabled.
48 USB mode virtual serial
2
3
48 Setting the first position at power ON enabled.
49 (Default) USB mode printer class
48 Paper heading cut disabled.
4 48 (Default) Reserve
3
49 (Default) Paper heading cut enabled.
48 (Default) Reports the power off.
5
48
Uses Black mark paper/ label paper
49 Does not report power off.
4
49 (Default)
Uses thermal roll paper
48 (Default) Undefined
6
48 (Default) Detects paper position and black mark.
48 (Default) Undefined
7
5
49 Detects paper position and inter-label distance.
8 48 (Default) Undefined
Reserved
6 48 (Default)
Reserved
7 48 (Default)
48 Forcible partial cut disabled.
8
Forcible partial cut enabled (full but by command:
enabled).
49 (Default)
*Initial value differs depending on the destination.
Initial value of standard model is roll paper setting.
*Only BM/label model is valid. When roll paper is specified with bit 4, this
bit is invalid.
*When BM paper/label paper is selected, this bit is invalid (full cut at all
times).
- 162 -