Filter
Top Products
CT-S2000
• Setting memory with 1 (a = 1) • Setting memory switch 3 (a = 3)
n b (Set Value) Function n b (Set Value) Function
48 (Default) Reports the power on. 48 (Default) After clearing cutter error, can be restored by Feed SW.
1 1
49 Does not report power on.
49 After clearing cutter error, cannot be restored by Feed SW.
48 (Default) Sets input buffer capacity to 4K bytes.
2 48 (Default) Reserved
2
49 Sets input buffer capacity to 45 bytes.
48 (Default) Resets with parallel pin 31.
3
49 Does not reset with parallel pin 31.
48 (Default) Sets input buffer full and offline to be Busy.
3
4 48 (Default) Reserved
49 Sets to be busy with input buffer full.
5 48 (Default) Reserved
At the occurrence of receiving error, replaces the data with
“?”.
48 (Default)
6 48 (Default) Undefined
4
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
48 (Default) Does not reset at serial I/F pin 25.
8
49 Resets sat serial I/F pin 25.
*With MSW1-2, parallel I/F (4K fixed) and USB I/F (16K fixed) are disabled.
With serial I/F, 45 bytes are enabled only when DMA control (MSW7-6) is
disabled.
• Setting memory switch 2 (a = 2)
n b (Set Value) Function
1 49 (Default) Reserve
48 Disables auto cutter.
2
49 (Default) Enables auto cutter.
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After cover close and PE recovery, prints as it is.
5
49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
6 48 (Default) Reserved
7 48 (Default) Reserved
48 (Default) Enables PNE.
8
49 Disables PNE.
48 (Default) Sets CBM1000-noncompatible mode. 7
49 Sets CBM11000-compatible mode.
Sets cover open error during printing to be auto recovery
error.
48 (Default)
8
Sets cover open error during printing to be recoverable
error.
49
• Setting memory switch 4 (a = 4)
n b (Set Value) Function
At the selection of Black mark paper, disables auto
end-measurement.
48 (Default)
1
At the selection of Black mark paper, enables auto
end-measurement.
49
2 48 (Default) Reserve
48 Paper heading cut disabled.
3
49 (Default) Paper heading cut enabled.
4 48 (Default) Undefined
5 48 (Default) Undefined
6 48 (Default) Undefined
7 48 (Default) Undefined
48 Forcible partial cut disabled.
8
Forcible partial cut enabled (full but by command:
enabled).
49 (Default)
- 159 -