Filter
Top Products
142
Parameter Name Description Type
netmask Netmask of the PIF, defined here if IP-
configuration-mode is static; undefined if
supplied by DHCP
read only
gateway Gateway address of the PIF, defined here if
IP-configuration-mode is static; undefined if
supplied by DHCP
read only
DNS DNS address of the PIF, defined here if IP-
configuration-mode is static; undefined if
supplied by DHCP
read only
io_read_kbs average read rate in kB/s for the device read only
io_write_kbs average write rate in kB/s for the device read only
carrier link state for this device read only
vendor-id the ID assigned to NIC's vendor read only
vendor-name the NIC vendor's name read only
device-id the ID assigned by the vendor to this NIC
model
read only
device-name the name assigned by the vendor to this NIC
model
read only
speed data transfer rate of the NIC read only
duplex duplexing mode of the NIC; full or half read only
pci-bus-path PCI bus path address read only
other-config:ethtool-
speed
sets the speed of connection in Mbps read write
other-config:ethtool-
autoneg
set to no to disable autonegotiation of the
physical interface or bridge. Default is yes.
read write
other-config:ethtool-
duplex
Sets duplexing capability of the PIF, either
full or half.
read write
other-config:ethtool-rx set to on to enable receive checksum, off
to disable
read write
other-config:ethtool-tx set to on to enable transmit checksum, off
to disable
read write
other-config:ethtool-sg set to on to enable scatter gather, off to
disable
read write
other-config:ethtool-tso set to on to enable tcp segmentation
offload, off to disable
read write
other-config:ethtool-ufo set to on to enable udp fragment offload,
off to disable
read write