Filter
Top Products
165
Parameter Name Description Type
MTU Maximum Transmission Unit
of the VIF in bytes. This
parameter is read-only, but you
can override the MTU setting
with the mtu key using the
other-config map parameter.
For example, to reset the MTU
on a virtual NIC to use jumbo
frames:
xe vif-param-set \
uuid=<vif_uuid> \
other-config:mtu=9000
read only
currently-attached true if the device is currently
attached
read only
qos_algorithm_type QoS algorithm to use read/write
qos_algorithm_params parameters for the chosen QoS
algorithm
read/write map parameter
qos_supported_algorithms supported QoS algorithms for
this VIF
read only set parameter
MAC-autogenerated True if the MAC address
of the VIF was automatically
generated
read only
other-config Additional configuration
key:value pairs
read/write map parameter
other-config:ethtool-rx set to on to enable receive
checksum, off to disable
read write
other-config:ethtool-tx set to on to enable transmit
checksum, off to disable
read write
other-config:ethtool-sg set to on to enable scatter
gather, off to disable
read write
other-config:ethtool-tso set to on to enable tcp
segmentation offload, off to
disable
read write
other-config:ethtool-ufo set to on to enable udp
fragment offload, off to
disable
read write
other-config:ethtool-gso set to on to enable generic
segmentation offload, off to
disable
read write