Filter
Top Products
CY7C67200
Document #: 38-08014 Rev. *G Page 20 of 78
Host n Control Register [R/W]
• Host 1 Control Register 0xC080
• Host 2 Control Register 0xC0A0
Figure 18. Host n Control Register
Register Description
The Host n Control register allows high-level USB transaction
control.
Preamble Enable (Bit 7)
The Preamble Enable bit enables or disables the transmission
of a preamble packet before all low-speed packets. This bit
should only be set when communicating with a low-speed
device.
1: Enable Preamble packet
0: Disable Preamble packet
Sequence Select (Bit 6)
The Sequence Select bit sets the data toggle for the next
packet. This bit has no effect on receiving data packets;
sequence checking must be handled in firmware.
1: Send DATA1
0: Send DATA0
Sync Enable (Bit 5)
The Sync Enable bit synchronizes the transfer with the SOF
packet in full-speed mode and the EOP packet in low-speed
mode.
1: The next enabled packet will be transferred after the SOF
or EOP packet is transmitted
0: The next enabled packet will be transferred as soon as the
SIE is free
ISO Enable (Bit 4)
The ISO Enable bit enables or disables an Isochronous trans-
action.
1: Enable Isochronous transaction
0: Disable Isochronous transaction
Arm Enable (Bit 0)
The Arm Enable bit arms an endpoint and starts a transaction.
This bit is automatically cleared to ‘0’ when a transaction is
complete.
1: Arm endpoint and begin transaction
0: Endpoint disarmed
Reserved
All reserved bits must be written as ‘0’.
Bit # 15 14 13 12 11 10 9 8
Field Reserved
Read/Write - - - - - - - -
Default 0 0 0 0 0 0 0 0
Bit # 7 6 5 4 3 2 1 0
Field
Preamble
Enable
Sequence
Select
Sync
Enable
ISO
Enable
Reserved Arm
Enable
Read/Write R/W R/W R/W R/W - - - R/W
Default 0 0 0 0 0 0 0 0
[+] Feedback