Cypress CY7C67200 Computer Drive User Manual


 
CY7C67200
Document #: 38-08014 Rev. *G Page 40 of 78
VBUS Valid Flag (Bit 0)
The VBUS Valid Flag bit indicates whether OTG VBus is
greater than 4.4V. After turning on VBUS, firmware should wait
at least 10 µs before this reading this bit.
1: OTG VBus is greater then 4.4V
0: OTG VBus is less then 4.4V
Reserved
All reserved bits must be written as ‘0’.
GPIO Registers
There are seven registers dedicated for GPIO operations. These seven registers are covered in this section and summarized in
Table 29.
GPIO Control Register [0xC006] [R/W]
Figure 41. GPIO Control Register
Register Description
The GPIO Control register configures the GPIO pins for
various interface options. It also controls the polarity of the
GPIO interrupt on IRQ0 (GPIO24).
Write Protect Enable (Bit 15)
The Write Protect Enable bit enables or disables the GPIO
write protect. When Write Protect is enabled, the GPIO Mode
Select [15:8] bits are read-only until a chip reset.
1: Enable Write Protect
0: Disable Write Protect
SAS Enable (Bit 11)
The SAS Enable bit, when in SPI mode, reroutes the SPI port
SPI_nSSI pin to GPIO[15] rather then GPIO[9].
1: Reroute SPI_nss to GPIO[15]
0: Leave SPI_nss on GPIO[9]
Mode Select (Bits [10:8])
The Mode Select field selects how GPIO[15:0] and
GPIO[24:19] are used as defined in Table 30.
Table 29.GPIO Registers
Register Name Address R/W
GPIO Control Register 0xC006 R/W
GPIO0 Output Data Register 0xC01E R/W
GPIO0 Input Data Register 0xC020 R
GPIO0 Direction Register 0xC022 R/W
GPIO1 Output Data Register 0xC024 R/W
GPIO1 Input Data Register 0xC026 R
GPIO1 Direction Register 0xC028 R/W
Bit # 15 14 13 12 11 10 9 8
Field
Write Protect
Enable
Reserved Reserved SAS
Enable
Mode
Select
Read/Write R/W - R - R/W R/W R/W R/W
Default 0 0 0 0 0 0 0 0
Bit # 7 6 5 4 3 2 1 0
Field
HSS
Enable
Reserved SPI
Enable
Reserved Interrupt 0
Polarity Select
Interrupt 0
Enable
Read/Write R/W - R/W - - - R/W R/W
Default 0 0 0 0 0 0 0 0
Table 30.Mode Select Definition
Mode Select
[10:8]
GPIO Configuration
111 Reserved
110 SCAN – (HW) Scan diagnostic. For produc-
tion test only. Not for normal operation
101 HPI – Host Port Interface
100 Reserved
011 Reserved
010 Reserved
001 Reserved
000 GPIO – General Purpose Input Output
[+] Feedback