Dell MD3000i Network Router User Manual


 
Instructions to Configure BFi for Broadcom NIC 39
Configuring Boot From iSCSI (BFi)
Using Broadcom™ NetXtreme
Network Adapter on a System That
is Configured With a Local Disk
This section provides information about configuring a Dell™ PowerEdge™
system to boot from an Internet Small Computer System Interface (iSCSI)
solution using the Broadcom
®
NetXtreme
®
network adapter when the base
system has a local disk.
To create the operating system base image, you must initially configure the
PowerEdge system with a local hard drive. After the operating system image is
created and is cloned to the iSCSI Logical Unit Number (LUN), the
PowerEdge system does not require a local hard drive for booting.Before
implementing a boot from iSCSI LUN:
See "Additional Information" on page 53 and the
Broadcom iSCSI Boot
User’s Guide
.
Configure IP addresses for the iSCSI ports on ton the Dell PowerVault™
MD3000i storage array.
NOTE: Throughout this document, the term host refers to the PowerEdge system on
which you configure Boot From iSCSI (BFi). The terms iSCSI LUN and iSCSI target
refer to the LUN in the Dell PowerVault MD3000i Integrated solution from which you
perform the boot.