Dell MD3000i Network Router User Manual


 
72 Replacing Broadcom NIC Configured for BFi
Table C-1. MS-DOS Commands
Command/Parameters Description
-GET Saves iSCSI boot configuration settings in the Electrically
Erasable Programmable Read-Only (EEPROM) to a disk file
on the selected iSCSI-capable port. You must specify a file
name with the -FILE parameter.
NOTE: For security reasons it is recommended that you disable
Challenge Handshake Authentication Protocol (CHAP) settings
when using the save command. If you do not disable these
settings, ensure that you keep the file secure.
-SET Restores previously saved iSCSI boot configuration settings
on the selected iSCSI boot-capable port.
NOTE: For security reasons it is recommended that you disable
CHAP settings when using the restore command. If you do not
disable these settings, ensure that you keep the file secure.
NOTE: This feature may create multiple primary or secondary
ports. Review the boot priority setting in the firmware setup
before you reboot the system.
-DEV <MAC
address>
Where MAC address
is Physical address of
the NIC.
Selects a specific iSCSI Boot-capable adapter in the system.
NOTE: MS-DOS limits the filename to eight characters.