Dell MD3000i Network Router User Manual


 
Instructions to Configure BFi for Broadcom NIC 49
16
Press <Esc> twice to exit the
Configuration Menu
. Select
Exit and Save
Configuration
and press <Enter>.
NOTE: Skip step 17 to step 19 if Windows HBA mode is set to Enabled. Redundant
paths to the target is not supported for iSCSI boot over HBA. You can create
redundancy for Data I/O by creating a connection manually in the Microsoft
iSCSI initiator for the additional Network adapters. Refer to the iSCSI target
user manual for specific guidance to create the connection.
17
Press <Esc> to go back to the main menu. Select
Secondary Device
Parameters
and press the <Enter> key.
18
In the
Secondary Device Parameters
screen, select
Configure Secondary
and press <Enter>.
19
Repeat step 14 and step 15.
20
Press <Esc> and <F4> to save and exit from the
Broadcom MBA
Configuration
menu.
The host now boots from the iSCSI LUN.
Cloning
If you intend to create an operating system image to deploy to multiple hosts,
run Sysprep prior to cloning the LUN.
1
In the system drive root, create a directory and name it as
Sysprep
.
2
In your operating system media, locate the archive file
support\tools\deploy.cab
and copy all the contents to the
Sysprep
directory.
3
Use the
setupmgr.exe
utility to create the
sysprep.inf
file and follow the on
the screen instructions to provide specific information.
4
In the
Sysprep.inf
file, edit the
[Unattended]
section as shown below:
[Unattended]
LegacyNic=1
5
Run
Sysprep
.
6
To create an operating system image, select
Reseal
and
Shutdown
.