Dell MD3000i Network Router User Manual


 
48 Instructions to Configure BFi for Broadcom NIC
7
Clone the operating system partition to the Fat32 partition (partition to
image) or network share (disk to image).
8
Reboot the host and boot into the operating system on the local hard drive.
9
Launch Windows compatible cloning software such as Ghost32
application and write the image in Fat32 partition (or network share) to
the remote LUN.
10
Go to the BIOS menu, disable the local hard drive and reboot.
11
During BIOS POST, press <Ctrl><s> to enter Broadcom MBA
configuration menu.
12
Press <Ctrl><k> to enter iSCSI boot configuration menu.
13
Select the device from the list that was previously configured for iSCSI
boot and press <Enter>.
14
Select
General Parameters
from the menu and press <Enter>.
15
Configure Boot to iSCSI target to
Enabled
as shown in
Figure 4-2
.
Figure 4-2. Configuring General Parameters