Filter
Top Products
Dell
TM
XFR D630 Fully Rugged Notebook Service Manual
Page 52 of 106 Revision A01
1
memory module (DIMM A)
2
securing clips (2)
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the
memory-module securing clips.
4. If you are replacing a memory module, ground yourself and remove the existing module:
a. Use your fingertips to carefully spread apart the securing clips on each end of the memory
module connector until the module pops up.
b. Remove the module from the connector.
1
securing clips (2)
2
memory module
5. Ground yourself and install the new memory module:
a. Align the notch in the module connector with the tab in the connector slot.
b. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down
until it clicks into place. If you do not feel the click, remove the module and reinstall it.
NOTE: If the memory module is not installed properly, the computer may not boot properly.
No error message indicates this failure.