Filter
Top Products
Dell
TM
XFR D630 Fully Rugged Notebook Service Manual
Page 92 of 106 Revision A01
NOTICE: If you are servicing the system board, RF Passthru board or bottom chassis, continue
with next steps to remove the PC Card interface board.
10. Remove the screw and then disconnect the interface board connector from the system board.
Remove the PC Card interface board.
19.2 Installing the PC Card Cage
NOTICE: If you removed the PC Card Reader only, skip to step 2. If you also removed the PC
Card interface board, start with step 1.
1. Install the PC Card interface. Connect the PC Card interface board to the system board and
secure with the screw to the bottom chassis.
2. Install the PC Card cage. Connect the PC Card Reader cable to the interface board. Install the
four M2x3-mm screws.
3. Replace the palm rest (see
230H
Installing the Palm Rest
).
NOTE: Ensure that you reconnect the coin-cell battery (see
231H
Coin-Cell Battery
) before you replace
the keyboard.
4. Replace the display assembly (see
232H
Installing the Display Assembly
).
5. Replace the keyboard (see
233H
Keyboards
).
6. Replace the media bay device (see
234H
XBay Devices
).
7. Replace the hinge cover (see
235H
Installing the Hinge Cover
).
8. Replace the battery.
20 Speaker
CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User’s Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the
computer).
20.1 Removing the Speaker
1. Follow the instructions in
236H
Before You Begin
.
2. Remove the hinge cover (see
237H
Removing the Hinge Cover
).
3. Remove any installed media bay device (see
238H
XBay Devices
).
4. Remove the keyboard (see
239H
Keyboards
).
5. Remove the display assembly (see
240H
Removing the Display Assembly
).