Filter
Top Products
Dell
TM
XFR D630 Fully Rugged Notebook Service Manual
Page 56 of 106 Revision A01
10.1 Removing the Display Assembly
CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User’s Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the
computer).
1. Follow the instructions in
111H
Before You Begin
.
2. Remove the hinge cover (see
112H
Removing the Hinge Cover
).
3. Remove the keyboard (see
113H
Keyboards
).
NOTICE: To avoid damage to your computer, carefully reroute the cables in the appropriate
cable channels when replacing the display. Route the gray and black antenna cables beneath the
white antenna cable, and the black display cable on top of the white antenna cable.
NOTICE: For the optional Touch Screen Display, remove the touch controller cable from the I/O
board on the right side, near the right hinge.
4. Unplug the display cable:
a. Pull straight up on the pull-tab that is attached to the display-feed flex cable to
disconnect the cable from the system board.
NOTE: The following step is only for the optional Touch Screen display.
b. Disconnect the touch controller cable from the motherboard controller cable,
above the heat sink.
5. Disconnect the antenna cables from their card(s) (see
114H
WLAN Card
and
115H
RF Passthru Board
).
1
WLAN card
2
antenna cable connectors
3
RF Passthru cable connector
4
Display cable connector
1
2
3
4