Filter
Top Products
Dell
TM
XFR D630 Fully Rugged Notebook Service Manual
Page 64 of 106 Revision A01
CAUTION: Before working inside your computer, follow the safety instructions in the
XFR D630 Product Information Guide and in the XFR D630 User’s Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on the back of the
computer).
1. Follow the instructions in
121H
Before You Begin
.
2. Remove the display assembly (see
122H
Removing the Display Assembly
).
NOTE: Ensure the display cable grommets were removed by following the grommet removal
instructions provided in
123H
Removing the Display Assembly
at step 13.
3. Remove the display bezel (see
124H
Removing the Display Bezel
).
4. Remove hinges. Remove 3 M2.5 x 5-mm screws from each side of the display panel and
remove the hinge from each side.
CAUTION: To avoid damage to your display panel, handle the panel by the bracket tabs
only.
5. Pull the LVDS cable thru the rubber grommet in the LVDS/antenna cable assembly, near the
right side hinge. These antenna cables are part of the back cover assembly and must be
separated from the LVDS cable to allow removal of the Display Panel.