Filter
Top Products
Dell
TM
XFR D630 Fully Rugged Notebook Service Manual
Page 80 of 106 Revision A01
1
touch pad connector
14.2 Installing the Palm Rest
NOTICE: When reinstalling the palm rest, ensure that you reconnect the USB cable to the IO
dash board, and then reconnect the touch pad cable connector to the system board before
replacing the palm rest screws.
NOTE: If you are replacing the palm rest, remove the USB Control cable from the original palm
rest and route the same way in the new palm rest.
Underside of Palm Rest showing Touchpad Cable Route
1. Install the 5 top-side screws.
2. Turn the system over.
3. Install the 11 bottom screws.
4. Reconnect the coin-cell battery (see
172H
Coin-Cell Battery
).
Touch pad
connector
Touchpad
cable