Delta Electronics VFD-EL Power Supply User Manual


 
Chapter 4 Parameters|
4-2 Revision August 2008, 2ELE, V1.02
4.1 Summary of Parameter Settings
: The parameter can be set during operation.
Group 0 User Parameters
Parameter Explanation Settings
Factory
Setting
Customer
00.00 Identity Code of the
AC motor drive
Read-only ##
00.01 Rated Current
Display of the AC
motor drive
Read-only #.#
0: Parameter can be read/written
1: All parameters are read only
8: Keypad lock
9: All parameters are reset to factory settings
(50Hz, 230V/400V or 220V/380V depends on
Pr.00.12)
00.02 Parameter Reset
10: All parameters are reset to factory
settings (60Hz, 220V/440V)
0
0: Display the frequency command value
(Fxxx)
1: Display the actual output frequency (Hxxx)
2: Display the content of user-defined unit
(Uxxx)
3: Multifunction display, see Pr.00.04
00.03
Start-up Display
Selection
4: FWD/REV command
0
0: Display the content of user-defined unit
(Uxxx)
1: Display the counter value (c)
2: Display the status of multi-function input
terminals (d)
3: Display DC-BUS voltage (u)
4: Display output voltage (E)
5: Display PID analog feedback signal value
(b) (%)
00.04
Content of Multi-
function Display
6: Output power factor angle (n)
0