Filter
Top Products
50
Chapter 6 Command Definitions
6.5.3 CNBOP – Configuration Board Print
Synopsis
This command gives a print out of all configured boards.
Syntax
CNBOP;
Prerequisites
None
Attributes
None
Examples
CNBOP;
Output Format
Board Configuration
BPOS BRDTYPE SIGTYPE
1 SPCI2S-4-2 SS7
3 SPCI2S-4-2 SS7
EXECUTED
6.5.4 CNBUI – Configuration Back Up Initiate
Synopsis
This command backs up either the configuration data or the current software distribution to a Remote Data
Centre (RDC).
A filename (FILE) should be entered on the command line without a suffix. The command automatically
reads the filename with a suffix. The command determines the suffix from the DTYPE parameter. For
example, if the user specifies FILE=CFG and DTYPE=CONFIG, the full filename would be CFG.CF4.
The file suffix and default filename for each DTYPE is as follows:
• For DTYPE=CONFIG, the filename suffix is .CF3. If a filename is not specified, the default is “SDC”.
• For DTYPE=SOFTWARE, the filename suffix is .tgz. If a filename is not specified, the default is “sgw”.
Optionally, the file may be backed up to a subdirectory (DIRECTORY) of the account on the RDC.
Note: During execution of this command, the system may not respond for up to three minutes while
the command is being executed.
Syntax
CNBUI:RDC=,DTYPE=,[FILE=,][DIRECTORY=,];
Prerequisites
• The RDC should be initiated and not blocked.
• The DTYPE can only be CONFIG or SOFTWARE.
• If the RDC is the “local” RDC, a FILE name of SDC or SGW is not allowed.
Attributes
None
Examples
CNBUI:RDC=1,DTYPE=CONFIG,FILE=SDC;