Filter
Top Products
88
Chapter 6 Command Definitions
6.9.5 MNRSI – Maintenance Restart System Initiate
Synopsis
This command restarts the entire system. All current logon sessions are terminated.
If a software update disk is present, in the CD-ROM drive, then the software update procedure commences.
If no software update disk is present, but a CD containing a configuration dump is present, this configuration
is loaded into memory and the system restarts.
In all other cases, no change to the system configuration occurs and the state of all links is automatically
restored.
If RESET is set to Y, all configuration data is removed.
If SYSTYPE is set, the systems operating mode changes after restart. Possible operation modes are:
• DSC – Digital Signaling Conveter
• SGW – SIGTRAN Signaling Gateway
• SIU – Signaling Interface Unit
Syntax
MNRSI:[RESTART=,][RESET=Y,][SYSTYPE=,];
Prerequisites
• SYSTYPE can only be set to system types that have been licensed for the unit. See the CNSYP command.
Note: SIU is always licensed.
Attributes
PROMPT
Examples
MNRSI;
MNRSI:RESET=Y;
MNRSI:SYSTYPE=SGW;