Filter
Top Products
52
Chapter 6 Command Definitions
6.5.7 CNMOP – Configuration Monitor Print
Synopsis
This command is used to obtain a print out of the objects being monitored. An object is currently only a
signaling link.
For signaling, the STS monitors information sent from the EQU of the signaling link and the RTS monitors
information received by the signaling link.
Syntax
CNMOP;
Prerequisites
None
Attributes
None
Examples
CNMOP;
Output Format
Monitoring Configuration
C7LINK STS RTS
1 3-3-1 3-3-2
3 3-3-3 3-3-4
EXECUTED
6.5.8 CNPCI – Configuration PCM Initiate
Synopsis
This command configures a PCM (PCM) for T1 or E1 operation (PCMTYPE) on a board such that it is available
for signaling or voice. The command optionally configures the PCM to be used as a potential synchronization
source for the system (SYNCPRI). The command also allows the frame format (FF) and line code (LC) to be
configured. See Section 7.1.2, “Boards and PCMs” on page 136 for a more detailed description of PCM
configuration.
Syntax
CNPCI:PCM=,PCMTYPE=,[SYNCPRI=,][FF=,][LC=,][IDLE=][BM=][BUILDOUT=,];
Prerequisites
• The board on which the PCM exists has been initiated.
• The PCM has not already been initiated.
• For a PCMTYPE of E1, the LC can be set to HDB3 and the FF can be set to G704, CRC4, CRC4C or
CRC4G706.
• For a PCMTYPE of T1, the LC can be set to AMI or B8ZS and the FF can be set to SF, ESF or CRC6.
• An FF of CRC4G706 can only be set on a board type of SS7HDP.
• The BUILDOUT parameter can only have a value of 0 for E1 and a value of 1 for T1s on boards of a type
other than SS7HDP.
Attributes
CONFIG
Examples
CNPCI:PCM=1-1,PCMTYPE=E1,SYNCPRI=1;