Filter
Top Products
85
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.9.1 MNBLI – Maintenance Blocking Initiate
Synopsis
This command initiates blocking for boards, signaling links, remote data centres, SIGTRAN links and
SIGTRAN Application Servers. A blocking command removes from use the board, link, route or server
covered by the command, it also removes their configuration data from the lower levels of the Signaling
Gateway and only configuration management maintains knowledge of their existence.
Possible grouping are:
• SS7 signaling links
• Boards
• Remote Data Centres (RDCs)
• SIGTRAN signaling links
• SIGTRAN Application Servers
If the grouping being blocked is already in the blocked state, no action is taken.
If a C7 link has been inhibited, the inhibiting is removed as part of the blocking action.
Syntax
MNBLI:C7LINK=…;
MNBLI:BPOS=…;
MNBLI:RDC=…;
MNBLI:SNLINK=…;
MNBLI:AS=…;
Prerequisites
• The item being blocked has been initiated.
• When blocking a board, all SS7 links on the board must already be blocked.
• If this is the last RDC to be blocked, then it cannot be blocked until all continuous records and periodic
reports are ended.
• An SNLINK of SNTYPE M2PA can only be blocked if its associated C7LINK is either blocked or inhibited.
Attributes
CONFIG,PROMPT
Examples
MNBLI:SNLINK=12;
MNBLI:C7LINK=4;
Output Format
Blocking C7LINK 1
Blocking C7LINK 2
EXECUTED