Filter
Top Products
61
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.21 CNTOS – Configuration Timeout Value Set
Synopsis
This command is used to change the value of a timer for a particular signaling system.
The user should specify the timer type (TTYPE), the timer itself (TO) and time that it should be set to,
expressed in either seconds (TSEC) or milliseconds (TMSEC).
Note: Some signaling system timer values are not changeable.
See the CNTOP command to verify timer values. See Section 5.3, “Signaling Gateway Timers” on page 38 for
the definition of signaling system specific timers.
Syntax
CNTOS:TTYPE=,TO=,{TSEC=|TMSEC=};
Prerequisites
None
Attributes
CONFIG
Examples
CNTOS:TTYPE=MTP3,TO=7,TSEC=30;
6.5.22 CNTOP – Configuration Timeout Value Print
Synopsis
This command is used to print the value of either a single timer or all the timers for a particular protocol
module. (Refer to CNTOS command to set timer values.)
Syntax
CNTOP:TTYPE=,[TO=,];
Prerequisites
None
Attributes
None
Examples
CNTOP:TTYPE=MTP3;
Output Format
Timeout Values:
TTYPE TO TSEC TMSEC
MTP3 1 60
MTP3 2 360
MTP3 3 120
MTP3 4 360
MTP3 5 5
MTP3 6 5
MTP3 7 3
MTP3 10 60
EXECUTED