Filter
Top Products
70
Chapter 6 Command Definitions
6.6.5 C7RTI – CCS SS7 Route Initiate
Synopsis
This command is used to initiate an SS7 Route (C7RT) to a Destination Point Code (DPC) within a Network
Context (NC). An SS7 Route utilizes one (LS1) or two (LS2) link sets which route via adjacent point codes to
reach the eventual destination (DPC).
On a per network context basis, a default MTP route may be specified. On a per network context basis, traffic
for all point codes not known to the Signalling Gateway are routed to the default route. A default route can
be specified by setting the DPC value on the route to DFLT.
See Section 7.2, “Signaling Configuration” on page 136 for a more detailed description of the SS7 signaling
configuration.
Syntax
C7RTI:C7RT=,DPC=,LS1=,NC=,[LS2=,][LSH=,][LABEL=,];
Prerequisites
• The NC must be the same as the NC of the underlying link sets.
• The DPC/NC combination must be unique.
• The link set specified has already been initiated.
• If the route is to an adjacent point code, then all links in the linkset to that point code must be either
inhibited or blocked.
• Only one default Route can be configured per Network Context.
• If a default route is specified, a network context cannot be configured with a DPC of 0.
Attributes
CONFIG
Examples
C7RTI:C7RT=1,LS1=1,DPC=130,LABEL=ROUTE130;