Dialogic SS7G2X Server User Manual


 
54
Chapter 6 Command Definitions
6.5.11 CNPCP – Configuration PCM Print
Synopsis
This command gives a printout of all the configured PCMs.
Syntax
CNPCP;
Prerequisites
None
Attributes
None
Examples
CNPCP;
Output Format
PCM Configuration
PCM PCMTYPE LC FF SYNCPRI IDLE BUILDOUT
1-2 E1 HDB3 G704 6 2A 0
2-2 E1 HDB3 G704 1 2A 0
3-1 T1 B8ZS SF 2 2A 7
EXECUTED
6.5.12 CNRDI – Configuration Remote Data Centre Initiate
Synopsis
This command is used to configure Remote Data Centre (RDC) so that data from periodic report or
continuous recording can be transferred to that location. The connection itself is established when the RDC is
unblocked.
An RDC is an account, with an FTP logon name (USER) and password (PASSWORD) on a remote system
(IPADDR) operating as an FTP server. No proprietary software is required to run on the remote system.
Note: If an RDC has previously been ended, but a file transfer was already in progress, subsequent
CNRDIs using that RDC fail with “NO SYSTEM RESOURCES” until the file transfer has completed.
To configure the Signaling Gateway to act itself as an RDC, the user must specify a local address (127.0.0.1)
together with the “siuftp” account name and password.
Note: Local operation functions only if the ftp server on the system is active.
Syntax
CNRDI:RDC=,IPADDR=,USER=,PASSWORD=,[LABEL=,];
Prerequisites
The RDC is not already initiated.
The IP address is not already in use.
Attributes
CONFIG
Examples
CNRDI:RDC=1,IPADDR=255.123.0.124,USER=JOHN,PASSWORD=BAZZA123;