Filter
Top Products
53
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.5.9 CNPCC – Configuration PCM Change
Synopsis
This command allows changes to the configuration of a PCM.
Syntax
CNPCC:PCM=,{[PCMTYPE=,]|[SYNCPRI=,][FF=,][LC=,][IDLE=][BM=][BUILDOUT=,]};
Prerequisites
• The PCM has already been initiated.
• For a PCMTYPE of E1, the LC can be set to HDB3 and the FF can be set to G704, CRC4, CRC4C or
CRC4G706.
• For a PCMTYPE of T1, the LC can be set to AMI or B8ZS and the FF can be set to SF, ESF or CRC6.
• An FF of CRC4G706 can only be set on a board type of SS7HDP.
• The BUILDOUT parameter can only have a value of 0 for E1 and a value of 1 for T1s on boards of a type
other than SS7HDP.
Attributes
CONFIG
Examples
CNPCC:PCM=1-1,SYNCPRI=3;
6.5.10 CNPCE – Configuration PCM End
Synopsis
This command ends the configuration of a PCM such that it is unavailable for voice or signaling.
Syntax
CNPCE:PCM=;
Prerequisites
• No timeslot on the PCM has been assigned to voice, signaling monitoring or cross connections.
• The board on which the PCM exists has been blocked.
Attributes
CONFIG
Examples
CNPCE:PCM=1-1;