Filter
Top Products
71
Dialogic
®
SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.6.6 C7RTC – CCS SS7 Route Change
Synopsis
This command is used to change the attributes of an SS7 Route. The DPC parameter in this command
supports an extra value ‘DFLT’. When a route is specified as default, messages destined for DPCs within the
network context that have not been configured by the system is sent to the default route.
Syntax
C7RTC:C7RT=,NC=,[DPC=,][LS1=,][LS2=,][LSH=,][LABEL=,];
Prerequisites
• If specified, LS2 must have same SS7MD, NI, NC, and OPC as LS1.
• If specified, LS1 must have same SS7MD, NI, NC, and OPC as LS2.
• The specified route has already been initiated.
• Any link set specified has already been initiated.
• The DPC/NC combination (associated with the route’s link sets) must be different for each route.
• If changing any parameter other than the LABEL, all SS7 signaling links must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling
are blocked and then unblocked.
• Only one default route can be configured per network context.
• If a default route is specified, a network context cannot be configured with a DPC of 0.
Attributes
CONFIG
Examples
C7RTC:C7RT=1,NC=1,LS1=2;