Filter
Top Products
D-Link DES-3250TG Standalone Layer 2 Switch
forwarded by the Switch, according to
any additional rule added (see below).
Select Deny to specify that packets that
do not match the access profile are not
forwarded by the Switch and will be
filtered.
Priority(0-7)
This parameter is specified if you want to
re-write the 802.1p default priority
previously set in the Switch, which is
used to determine the CoS queue to
which packets are forwarded to. Once
this field is specified, packets accepted
by the Switch that match this priority are
forwarded to the CoS queue specified
previously by the user.
Replace priority with − Click the
corresponding box if you want to re-write
the 802.1p default priority of a packet to
the value entered in the Priority field,
which meets the criteria specified
previously in this command, before
forwarding it on to the specified CoS
queue. Otherwise, a packet will have its
incoming 802.1p user priority re-written
to its original value before being
forwarded by the Switch.
For more information on priority queues,
CoS queues and mapping for 802.1p,
see the QoS section of this manual.
VLAN Name
Allows the entry of a name for a
previously configured VLAN.
Source MAC
Source MAC Address - Enter a MAC
Address for the source MAC address.
Destination MAC
Destination MAC Address - Enter a MAC
Address mask for the destination MAC
address.
802.1p (0-7)
Enter a value from 0-7 to specify that the
access profile will apply only to packets
with this 802.1p priority value.
Ethernet Type
Specifies that the access profile will
apply only to packets with this
hexadecimal 802.1Q Ethernet type value
(hex 0x0-0xffff) in the packet header. The
Ethernet type value may be set in the
form: hex 0x0-0xffff, which means the
user may choose any combination of
letters and numbers ranging from a-f and
from 0-9999.
To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the following
screen:
92