Filter
Top Products
D-Link DES-3250TG Standalone Layer 2 Switch
(urgent), ack (acknowledgement), psh
(push), rst (reset), syn (synchronize), fin
(finish).
src port mask - Specify a TCP port
mask for the source port in hex form (hex
0x0-0xffff), which you wish to filter.
dest port mask - Specify a TCP port
mask for the destination port in hex form
(hex 0x0-0xffff) which you wish to filter.
Select UDP to use the UDP port number
contained in an incoming packet as the
forwarding criterion. Selecting UDP
requires that you specify a source port
mask and/or a destination port mask.
src port mask - Specify a TCP port
mask for the source port in hex form (hex
0x0-0xffff).
dest port mask - Specify a TCP port
mask for the destination port in hex form
(hex 0x0-0xffff).
protocol id - Enter a value defining the
protocol ID in the packet header to mask.
Specify the protocol ID mask in hex form
(hex 0x0-0xffffffff).
Port
The user may set the Access Profile
Table on a per-port basis by entering an
entry in this field. Entering all will denote
all ports on the Switch. The port list is
specified by listing the lowest switch
number and the beginning port number
on that switch, separated by a colon.
Then the highest switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range
are separated by a dash. For example,
1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3 -
2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in
numerical order.
Packet Content Mask
The page shown below is the Packet Content Mask configuration window.
85