Filter
Top Products
Stackable NWay Ethernet Switch User’s Guide
102 Web-Based Network Management
You can change the
IP Address
,
Subnet Mask
, and
Default Gateway
on the Switch. If your are not using
BOOTP, enter the
IP Address
,
Subnet Mask
, and
Default Gateway
of the Switch. If you enable
BOOTP
Service
, you do not need to configure any IP parameters because a BOOTP server automatically assigns IP
configuration parameters to the Switch. Click
Apply
to activate the new settings.
The information above is described as follows:
♦
Management Module MAC Address
The Ethernet address for the device. Also known as the
physical address.
♦
BOOTP Service
The BOOTP protocol allows IP addresses, subnet masks, and default gateways to
be assigned on a central BOOTP server. If this option is enabled, when the Switch is first powered up
it will look for a BOOTP server to provide it with this information before using the supplied settings.
♦
IP Address
The host address for the device on the TCP/IP network.
♦
Subnet Mask
The subnet mask that controls subnetting on your TCP/IP network.
♦
Default Gateway
The IP address of the device, usually a router, that handles connections to other
subnets and/or other TCP/IP networks.
Switch
Figure 7-2. Configure Switch Stack window