Filter
Top Products
Stackable NWay Ethernet Switch User’s Guide
82 Using the Console Interface
Figure 6-38. Update Firmware and Configuration Files screen
After making your changes in the fields above, press REBOOT TO START UPDATE to initiate the update
sequence.
The fields you can set are:
♦
Software Update Mode
Set to either
network
or
SLIP
. Determines whether the configuration file
should be obtained through the Ethernet network or through the console port.
♦
TFTP Server Address
The IP address of the TFTP server where the runtime (switching software) or
configuration file is located. This entry is used only if the Firmware Update is set to
Enabled
.
♦
Firmware Update
Determines whether or not the Switch will try to look for a runtime image file on
the TFTP server.
♦
File Name
The complete path and filename of the runtime image file on your TFTP server to be
uploaded to the Switch.
♦
Use Config File
Toggle to
Enabled
to use the settings in a configuration text file when the switch is
reset (rebooted). The configuration file is explained in detail in the
Sample Configuration File
Appendix
.
♦
Config File Name
The complete path and filename on the TFTP server for the configuration file to
use.
Last TFTP Server Address
is a read-only field that displays the IP address of the last TFTP server to be
accessed.