Edirol V-44SW E1 Switch User Manual


 
20
Setup and Settings Guide
In shows and other situations where SD video is being output to LED displays or similar displays, you can output video from
the V-44SW’s HD/RGB OUT PGM connectors.
Make the following menu parameter settings. Set the parameters in accordance with your usage environment.
The connected LED display needs to be set up as follows.
V-44SW Settings
Settings Parameter Value
See Page
1. Output 1: Output Format (1080i) Sw, etc. Selects optimal format, e.g., “480/60p” or “480/60i”, for the output
device.
* When “1: System Frame Rate” below is set to 50-PAL, this
parameter can be set to 576/50p or 576/50i.
p. 30
3: Pre Scaling Mode There are times when excess video is displayed on the screen. In
such cases, Set the “3: Pre Scaling Mode” to Manual, then adjust
with the “4: Manual Pre Scaling” parameter.
p. 32
3. HD/RGB Input
2: HD/RGB Ch1
3: HD/RGB Ch2
4: HD/RGB Ch3
5: HD/RGB Ch4
4: Manual Pre Scaling
5: Scaling Type There may be instances where the aspect ratio of video input with
HD or RGB is not 4:3, it may be necessary to adjust the aspect ratio
while observing the screen.
If satisfactory results cannot be obtained with “Full Scale,” “Fixed
Aspect: Letter,” or “Fixed Aspect: Crop,” select “Manual.” After
selecting “Manual,” adjusts the “6: Manual X Scale” and “7: Manual Y
Scale” parameters.
1: System Frame Rate Select the format appropriate for the output device you are using. p. 35
Settings for Devices Other Than the V-44SW
Device Setting
LED display or other device
Set the input to “Component Input.”
Outputting to an LED Display <SD Size (4:3) Output>
VGA cable Composite cable
S-Video cable
D-sub-5BNC cable
HD Camera
or Other Device
HD Video Output DeviceRGB Video Output Device
PC or Other Device
SD Video Output Device
DV Camera, Player,
or Other Device
V-44SW Rear Panel
D-sub-5BNC cable
Final Output (SD)
LED Display
or Other Display
V-44SW_e.book 20 ページ 2006年10月23日 月曜日 午後3時25分