Filter
Top Products
34
Setting the Input and Output
With SD video, there can be individual differences depending
on the type of device, so settings for the input should be made
individually.
1
Press the [MENU] button to display the Main menu.
2
Select “2. SD Input” and then select the channel you
want to set with “1: SD Ch1”–“4: SD Ch4” in the sub-
menu.
You can make changes to the following parameters.
●
It may be necessary to change the V-44SW’s input and output
formats to match the video signals (NTSC or PAL) being input.
For instructions on switching the input and output formats, refer to
“Selecting NTSC or PAL Format” (p. 35).
There may be instances in which the level of the
synchronization signal output by the SD video device is lower
than the standard value, with disruption of the video resulting
from the poor synchronization.
In such instances, select “8. System” in the menu and adjust
the value in “3: SD Input Sync Threshold.” You may be able to
synchronize the video and have it display properly.
Setting the SD Input
2. SD Input
→
SD Ch Sub Menu (
☞
p. 55)
1:
SD Input Select
Selects the SD input
Auto:
The connector used for the SD signals
being input is selected automatically. If
SD signals are being input to both
connectors on the same channel, the
S-VIDEO IN connector is selected.
S-Video:
Only the input from the S-VIDEO IN
connector is selected.
Composite:
Only the input from the COMPOSITE
IN connector is selected.
2: SD Brightness Brightness adjustment
3: SD Contrast Contrast adjustment
4: SD Saturation Saturation adjustment
5: SD Hue Hue adjustment
6: SD Sw Enable Sets the Enable/Disable status for the
channel select buttons
For more detailed information, refer to the
column, “To Prevent Errors in Using the
Channel Select Buttons” (p. 37).
7: SD Reset The sub-menu settings are returned to
their factory default settings (
☞
p. 29).
SD signals are input to the “SD section” then pass through
the “HD/RGB section” before being output (p. 9). Thus,
the two following types of settings are required in
adjusting the SD video.
Settings for the SD video input to the “HD/RGB
section”
☞ “Setting the HD/RGB Input” (p. 32)
Settings for the SD video input to the “SD section”
☞ Settings in this section
* Make the settings for before the settings in .
1
2
1
2
SD Signals: Compatible Input Formats
NTSC
59.94Hz Composite video format
S-Video format
PAL 50Hz Composite video format
S-Video format
If the Video is Disrupted
V-44SW_e.book 34 ページ ２００６年１０月２３日 月曜日 午後３時２５分