Emerson Network Router Network Router User Manual


 
30 ProLink
®
II Software for Micro Motion
®
Transmitters
Installation and Setup
Figure 2-13 License window
c. Enter the site key into the
Site Key textbox, then click the Validate button.
Note: To minimize the possibility of error, Micro Motion recommends copying and pasting the site key,
rather than typing the value.
2.3 Troubleshooting the ProLink II installation
If you have problems with the ProLink II installation, review the information in this section and
follow the suggestions. If you cannot resolve the problem, contact Micro Motion customer support.
2.3.1 Insufficient privileges
If you are unable to install ProLink II on a Windows NT, Windows 2000, or Windows XP system,
verify that you have the required privileges (see Section 2.2.1). On Windows NT, you must be logged
on as Administrator to perform the ProLink II installation.
2.3.2 Missing or corrupt registry entries
During a successful ProLink II installation, information is written to the Windows registry. If, for any
reason, ProLink II information in the registry is corrupted or missing, you can replace or update the
required information as follows:
1. Click
Start > Programs > MMI > ProLink II v2.5 > ProLink II Registrar.
2. A batch file that updates the Windows registry will be executed. Click
OK as required by the
pop-up messages.
3. Close the command window.
Note: To run the batch file on Windows NT, Windows 2000, or Windows XP systems, you must be
authorized to write to the registry.